Operation of parallel uninterruptible power supplies (Ups), whether parallel-redundant or parallel-capacity, centres on such criteria as mode of carrying out (supply present or provide failure), battery operation, handling of provide restoration, fault health and overload. It also depends upon whether they are related to a singular or dual input power supply.
The rectifier and static switch bypass provide inputs are taken from a common ac provide point (building incomer) and each uninterruptible power provide module is fitting with isolators or circuit breakers to allow individual disconnection. Each module will also have its own battery set.
Power Inverter With Battery
The output of each Ups module is taken to a common ac busbar where it is then distributed to necessary loads. This configuration of Ups is also fitted with an urgency bypass switch (switchgear panel). For future expansion, a spare connection point is built into the switchgear panel.
Operational Mode
In normal operation, where mains power provide or back-up power (diesel generator, for example) is present, each of the Ups modules shares the load equally.
During battery operation, when mains power and/or back-up are no longer available, each of the uninterruptible power provide modules in the parallel-redundant configuration will continue equally to share the load. Each one has its own battery set with the same runtime period and dc voltage cut off threshold. However, each battery set will removal at slightly different rates. During extended provide failures, the battery sets will removal until they reach their dc disconnect threshold.
Uninterruptible power provide modules will automatically restart when mains power is restored. To avoid upstream breaker tripping, start up sequence includes a soft-start activity to sacrifice the effects of high in-rush current.
Should any of the Ups modules detect an internal fault, they will automatically disconnect from the common output, in which case the remaining modules in the configuration pick up the load (without disruption) and share it equally.
If a second module in the parallel configuration fails, it will force the remaining modules into an overload health and the load will be transferred to bypass supplies via a static switch. This recipe of parallel Ups carrying out ensures the load receives an sufficient source of power automatically and without disruption.
When faced with an overload, the entire uninterruptible power provide will react in one of two ways - depending upon the magnitude and period of the overload. Firstly, Ups inverters have overload capabilities, so in the case of a small overload (within 100 - 150% of nominal rating), the Ups principles will continue to power the load from its inverter.
Secondly, for larger overloads that exceed the capabilities of the uninterruptible power supply, all the modules will automatically switch to bypass in an endeavor to clear the fault. They will remain like this until the fault is cleared or, if it continues, shutdown.
It is important to point out here that when in bypass, principles resilience is compromised, which is why modern uninterruptible power supplies have been designed and programmed to create alarm notifications, which can be monitored locally, via a network, or remotely.
Emergency bypasses are generally installed in parallel Ups configurations to allow modules to be electrically isolated and powered down when necessary.
With a dual input supply, the Ups principles is supplied from detach rectifier and static switch sources, which helps to enhance resilience and negates the single-point-of-failure related with singular supply.
Operation of a parallel-capacity uninterruptible power provide is the same as a parallel-redundant principles - except for how it handles Ups module failure. In this case, if one module fails, all of the remainder, plus the faulty one, will be forced into overload health and the load transferred to bypass. This ensured that the load continues to receive sufficient power automatically and without disruption.
There are a consolidate of useful accessories that can be incorporated into parallel Ups operation: a Ups Group Synchroniser (Ugs) and a Parallel Systems Joiner. A Ups Group Synchroniser synchronises the outputs from two detach groups of parallel Ups, which may be supplied from detach ac sources. It enables the outputs from the groups to be established into a dual bus format. A Parallel Systems Joiner operates in a similar vein but enables the connection of the two detach groups into a dynamic dual bus format, which facilitates principles expansion, fault tolerance and ease of maintenance.
Parallel Ups carrying out and Power protection Systems